How To Make Grey TV Stand
Grey TV stand – Building a flat screen TV stand is a project you can achieve with confidence. Measure the depth and width of the TV to determine the size of the stand. Be sure to include any component you plan to store on the stand as well. The next aspect to consider is the media material. The profile of a flat screen TV is thin enough to use lumber 2 by 12 inches of foot giving the appearance of a measurement. And then, put the two 60-inch pieces of wood on their 11 1/2-inch sides (top and bottom) on a work table. The position of them so that the long sides are touching and the ends are still. Then measure from the other end and make marks in 12 and 13 1/2 inches.
Place the square in the marks and draw lines through the grey TV stand material. Then, drill three pilot holes between the lines with a 1/16 inch drill bit. Drill one about 1 inch from the edges and one in the center. Turn the two pieces more than the lines are facing down. Drill the countersunk holes in the top of the pilot holes. Make them about 3/8-inch deep. Apply glue to 1/2 inch edges of 18 inch wood. Support the top and bottom pieces at their long edges so that the lines face each other. Align the ends of the spacers in the lines. Secure the spacers to the top and bottom with the drywall screws. Wipe off excess glue immediately with a damp cloth.
Position the TV stands more than the openings are facing up. Apply a bead of glue on the edges of the three spacers and the top and bottom between the dividers. Secure the 36 by 21 by 1/4 inch plywood to the bracket with the box studs. Clean the glue as before. Set the plywood 17 inches on the work table with the side 11 inches up. Measure from one 11-inch end of the face (it becomes the bottom) and make marks in, 11 and 12 1/2 inches. Then, place the square in the marks and draw lines through the material.
Apply glue to the 1/2 inch edge of the 11 inch ends of 14 inch plywood grey TV stand. Support the sides at their long edges and secure the shelves at the top, bottom and between the lines with the finishing nails. Clean the glue as before. Glue brush on the edges 3/4 inch ends 3 inches wood 14 5/8 inches with a small brush. Insert the stabilizer between the sides and the bottom of the top shelf. Fix it with the finishing nails. Slide the inserts into the TV bracket to the left and right of the middle spacer.dark wood floor living room, how to decorate grey tv stand, tv stand